01
Product design
Electronic design from requirement to a verified prototype, with every part chosen from lines we can actually buy at volume.
- Schematic capture and PCB layout
- Firmware bring-up
- EMC pre-compliance
Design & turnkey
From architecture to serial production, one accountable team.
Semixis takes electronics programmes end to end: design, prototype, qualification and turnkey build. Because the same team buys the components, the design is constrained from day one to parts that are authorised, available and sustainable.
Engagement model
- Fixed-scope design phases, reviewed before the next one starts
- Prototype through serial from a single bill of materials
- Lifecycle monitoring after release
Scope
What we take on
Three ways to engage, depending on how far your programme has already travelled. Most projects start at design and stay with us into production.
02
Design to turnkey
One contract from architecture through qualification and into serial build, so nothing falls between the design house and the factory.
- Prototype and pilot builds
- Tooling and test fixtures
- Serial test programme
03
Turnkey manufacturing
We take your released design, lock the bill of materials to authorised sources, and build, test and trace it end to end.
- BOM locking and sourcing
- SMT, assembly and box build
- Traceability records per unit
Process
How a programme runs
Each phase ends with a review pack and a decision, so cost and technical risk are visible before the next commitment.
- 01
Brief and feasibility
We take the requirement, compliance envelope and volume plan, then return a feasibility note with the architecture options worth pursuing.
- 02
Design and review
Schematic capture, stack-up, layout and a formal design review pack — with component choices constrained to authorised sources.
- 03
Prototype and test
Prototype builds, bring-up, EMC pre-compliance and a documented test report before any design is frozen.
- 04
Qualification and release
BOM locking, approved-vendor records, DFM review with the assembly house and a complete production documentation set.
- 05
Serial build and sustainment
Turnkey production through qualified channels, with lifecycle monitoring and change notice on any part that goes at risk.
Design enquiry
Tell us what you are building
A short brief is enough to start. We will come back with a feasibility read, the questions that matter and an indicative scope — not a sales sequence.
Worth including
- What the product must do, and the interfaces it carries
- Volumes per year and any committed delivery dates
- Compliance or certification the end product must meet
- Whether a design already exists, or we start from a requirement
Looking for components rather than a build? Send an RFQ and the quotation desk will answer it.